Radial Engineering Tonebone Uživatelský manuál stáhnout pdf (Strana 10)

True to the Music

Radial Engineering Loopbone Owner’s Manual

The Slingshot Remote

A powerful feature on the Loopbone is the Slingshot remote output. This

simple function allows you to hit a footswitch on the Loopbone, and

while doing so, instantaneously trigger another function on an amplifier

or effect. You could, for instance, change an amp channel, turn on a

reverb, or if you are using a midi controller, change several devices at

the same time.

You can also use the Loopbone’s Slingshot output feature with the other

Radial Tonebone pedals that have a Slingshot input such as the Cabbone

and the Headbone. Combined with the Cabbone, you could, for instance,

use a Loopbone footswitch to change speaker cabinets from a 2-12 for

clean sounds to a 4-12 for your fat chunky rhythm sounds. Combined

with the Headbone, you could use a Loopbone footswitch to switch amps

in the same way.

The beauty of the Slingshot is that it employs a very simple contact

closure that acts just like a typical amplifier footswitch. This means that

you can use regular ¼” guitar cables or ¼” TRS cables as the interface

between various pieces of equipment just like a midi set-up, but without

the prerequisite programming degree!

The Slingshot remote is easy to set up. Simply connect the Slingshot

remote output jack to your amplifier’s footswitch jack. Since this is a

basic contact closure, it is unlikely that you can damage any type of

switching system. If you are not sure, consult your dealer.

Detail showing Slingshot remote output connected to amplifier’s

footswitch jack for channel switching or reverb on/off.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15

Žádné komentáře

Radial Engineering Tonebone Uživatelský manuál Strana 10